External Halyard Flagpole Systems place the rope halyard on the outside of the flagpole.
These systems utilize flagpole trucks with an exposed pulley, rope halyard and flagpole cleat.
Options include include Stationary Trucks, which are fixed and will not rotate, and Revolving Trucks, which rotate the flag with the wind. A Double Revolving Truck is also available and includes an extra cleat and complete double halyard assembly.
Spindle Design Trucks incorporate a threaded spindle which is installed into a female fitting welded into the top of the flagpole.
Revolving Trucks rotate the flag with the wind.
Cap Design Trucks install over the top of the flagpole and are attached with anchoring set screws or bolts.
Stationary Trucks are fixed and will not rotate.
Internal Halyard Flagpole Systems enclose the halyard behind the security of a lockable access door.
Cam Cleat Systems incorporate rope halyard in a heavy-duty cam action cleat. Winch Systems incorporate wire halyard with a gearless Winch and Winch Handle.
Internal Trucks sit at the top of the flagpole, providing an enclosed pulley system for the Wire or Rope Halyard.
Options include Stationary Trucks, which are fixed and will not rotate, and Revolving Trucks, which rotate the flag with the wind.
Spindle Design Trucks incorporate a threaded spindle which is installed into a female fitting welded into the top of the flagpole.
Revolving Trucks rotate the flag with the wind.
Cap Design Trucks install over the top of the flagpole and are attached with anchoring set screws or bolts.
Stationary Trucks are fixed and will not rotate.
The exposed height in feet above grade and is measured to the top of the of the flagpole shaft. *When truck and ornaments are added, overall height can be greater by 1'-2', which can be relevant in areas with height ordinances. Upon request and at no additional charge, Mounting Heights can be shortened to achieve the desired overall height.
Standard Ground Set Flagpoles offered in 25' Mounting Heights are manufactured in a single piece with an overall length of 26'-6". Below grade, 2'-6" will be inserted into the Ground Sleeve. When the truck and finial are attached, the nominal height of the completed flagpole will be 25'. This industry accepted standard allows shipping in a pup trailer at a significant freight savings. Full 27'-6" shafts are available upon request.
The diameter in inches at the base of the shaft.
The diameter in inches at the very top of the shaft.
The thickness of the shaft in inches, varying from .125" to .500".
Flagpoles are available in both single and multi-piece designs. Flagpoles 45' and larger will contain multiple piece shafts based on Mounting Height. Sections can be easily field assembled without any loss of structural integrity, leaving only a hairline joint to indicate that the shaft is not a single piece flagpole.