Deluxe IH Flagpoles Information

Ground Set Cone Tapered Aluminum Flagpoles
General Information | Standard Finishes | Wind Chart | Deluxe IH Series Technical Drawings

These deluxe internal halyard flagpoles contain a winch mounted inside the flagpole shaft, operable only with a removable crank handle. As the stainless steel cable unwinds from the winch, it passes up through the inside of the flagpole shaft, over the truck sheave to the outside of the shaft, where the retaining ring provides a sliding anchor. A counterweight, heavily coated with neoprene, attached to the retaining ring, allows the halyard to be lowered for fastening or removing the flag. The halyard is then raised completely out of reach of vandals. The improved winch is gearless and self-locking at any point, eliminating the need for a separate brake. This direct drive winch provides rapid raising and lowering of the flag with little effort. This new, improved design does not require any welding, thus avoiding discoloration when an anodized finish is desired. No monthly lubrication is needed and this winch system is easily adaptable to existing on-site flagpoles.

Standard Finishes

Satin Aluminum (Standard)	Clear Anodized
Bronze #311 Anodized	Bronze #312 Anodized
Bronze #313 Anodized	Black Anodized

All flagpole shafts are highly polished with fine grain aluminum oxide cloth resulting in a high quality, deep satin lustre finish. This finish represents the ultimate in architectural finishes for aluminum flagpoles. The elegant, soft sheen remains maintenance free. In addition to satin, the following anodized finishes are available as standard colors: clear, light bronze #311, medium bronze #312, dark bronze #313 & black #335. Note: Of the three bronze finishes, dark bronze #313 is supplied unless otherwise specified.

Link to this page:

Send this link via E-Mail