IH-2 Flagpole Trucks
OFF
Description
For Internal Halyard Poles
Threaded Type
Revolving
Single Pulley
All of these cast aluminum trucks have a 1 1/4" NPT threaded spindle which screws into the top of the flagpole where a female fitting has been installed. The top of all trucks are designed to accept an ornament with a spindle threading of 1/2"-13NC as standard but can be supplied in other sizes of threading. The ornament is secured to the truck with a 1/4"-20NC stainless steel set screw. The extra large model has stainless steel sealed lubricant bearing assemblies while all other sizes utilize stainless steel ball bearings in both upper & lower bearing races. All sizes are supplied with a stainless steel bushing at the cable exit point except the IHT-3 which has a bronze fitting.
Outer Dimensions
IHT-VR: 5" (Base Diameter) x 4-1/2" (Height)
IHT-1: 6-1/2" (Base Diameter) x 6-1/2" (Height)
IHT-2: 8" (Base Diameter) x 7-1/4" (Height)
IHT-3: 10-1/2" (Base Diameter) x 8-1/2" (Height)
In certain cases, a Pole Top Adapter (PTA) is necessary as the top of the flagpole has a different threading or the existing truck is frozen and needs to be cut off.
Related Articles
Related FlagRunners
- 3 Tips to Prevent Flagpole Break-Downs: The Cathedral, Evansville IN, @BCCathedral
- Eyes of the Flag: Firestation #6, Syracuse, NY | @SyracuseFire
- American Flag in 40 mph Wind with Broken & Working Flagpoles
- What can wind tell you about your flagpole truck?
- The rope wrap-up: Flagpole Cleat Placement
- Signs of old flagpole trucks
- Flag Display at Abbott Labs in Palatine
- Commercial Aluminum Flag & Pole Maintenance | Rotating & Stationary Internal Halyard Truck Top Systems
- FlagRunners head to NATO Chicago Summit 2012
- Assembling and Raising a 30 ft. Flagpole
Related Categories
Link to this page:
IH-2 Flagpole Trucks